Digital RGB decorative led strip lights

RGBW101 sk6812RGBW LED Strip

Digital RGB decorative led strip lights
NEWSTAR LED CO., LIMITED
1. This LED strip is easy to install,with long lasting brightness and low voltage
2. This LED strip is completely flexible, you can twist it into any shape.
3. This LED strip light is the coolest way to decorate any vehicles. It's safe for indoor and outdoor decoration.
4. Manykinds of color modes for choice.
5.Many flash types.
6.Can keep any one color.
Digital Pixel APA102 LED chip diodes:http://www.newstar-ledstrip.com/products-195.html              

A data cable, two power lines, 12MM wide swatches, built-in IC, 256 gray levels can be achieved by the controller any effect can also be achieved, text, numbers, English, pictures, animations, and so on. (Controller:NS-T1000S )

NEWSTAR LED CO., LIMITED

NS-T1000S System features

    1、32—256 Gray level，Support software Gamma correction。

2、Support the rules and special-shaped handle.

3、Single-port output，can support 2048 pixels。

4、Off-line(SD Card) control, play back content stored on the SD card.

5、T-1000S store a maximum of 16 programs，copy multiple files to the SD card in order,

      after formatting the SD card as “FAT” format.

6、The program must be named in orders . just as ：00_1.led, 01_1.led, 02_1.led.

7、Compatible with single line or double line chips.

NOTE：1. When T-1000S controller control less than 512 lamps the frame rate can reach 30fps. When T-1000S control more than 512 lamps and less than 2048 lamps the frame rate will slow down automatically.

2. T-1000S must use the new software LedEdit 2013.

WSTAR LED CO., LIMITED

1.         Multiple T-1000S controllers can be cascaded together and work synchronously.

2.         T-1000S one TTL(SPI) signal and one RS485 signal port output，can control 2048 pixels/lamps；

3.         When the chip for LED is single line chip just with data, then just need to be connected with DAT and GND of the controller. If the chip for LED is double line chip with DAT and CLK, then need to be connected with DAT, CLK, and GND of the controller.

4.         If you need to use RS485 signal you need to connect controller A interface with LED lamps A (DMX+), controller B interface with LED lamps B(DMX-),

5.         If you need to control a new IC type by the controller， software code mode is：T-1000-IC model.

Application:

      1.Christmas/ Halloween show lighting;
2.For boat/barge decorations lighting;
3.Widely applicable as back lighting, cove lighting, decoration lighting,  for home furniture, club, bar, hotel, commercial center;      
4.Channel letter lighting using for stores, restaurants, bars;
5.Car interior and exterior lights;
6.Illumination lighting using walkway, canopy, stairway accent lighting, the amusement park; 
      7.Outdoor illuminated signs and advertisements.

NEWSTAR LED CO., LIMITED

APA102 LED Strip     RGBW LED Strip     WS2812B LED Strip